HD64F2638F20J Datasheet, PDF (1013/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Section 23B Power-Down Modes [HD64F2636UF, HD6432636UF, HD64F2638UF, HD6432638UF,
HD64F2638WF, HD6432638WF, HD64F2639UF, HD6432639UF, HD64F2639WF, HD6432639WF,
HD64F2630UF, HD6432630UF, HD64F2630WF, HD6432630WF, HD6432635F, HD64F2635F, HD6432634F]
When the STBY pin is driven low, a transition is made to hardware standby mode.
Figure 23B-2 shows the timing for transition to and clearance of medium-speed mode.
φ,
supporting module clock
Medium-speed mode
Bus master clock
Internal address bus
SBYCR
SBYCR
Internal write signal
Figure 23B-2 Medium-Speed Mode Transition and Clearance Timing
23B.4 Sleep Mode
23B.4.1 Sleep Mode
When the SLEEP instruction is executed when the SBYCR SSBY bit = 0 and the LPWRCR
LSON bit = 0, the CPU enters the sleep mode. In sleep mode, CPU operation stops but the
contents of the CPUís internal registers are retained. Other supporting modules do not stop.
23B.4.2 Exiting Sleep Mode
Sleep mode is exited by any interrupt, or signals at the RES, or STBY pins.
Exiting Sleep Mode by Interrupts: When an interrupt occurs, sleep mode is exited and interrupt
exception processing starts. Sleep mode is not exited if the interrupt is disabled, or interrupts other
than NMI are masked by the CPU.
Exiting Sleep Mode by RES pin: Setting the RES pin level Low selects the reset state. After the
stipulated reset input duration, driving the RES pin High starts the CPU performing reset
exception processing.
Exiting Sleep Mode by STBY Pin: When the STBY pin level is driven Low, a transition is made
to hardware standby mode.
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Page 963 of 1458