HD64F2638F20J Datasheet, PDF (313/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Section 9 I/O Ports
Port B MOS Pull-Up Control Register (PBPCR)
Bit
:
7
6
5
4
3
2
1
0
PB7PCR PB6PCR PB5PCR PB4PCR PB3PCR PB2PCR PB1PCR PB0PCR
Initial value :
0
0
0
0
0
0
0
0
R/W
: R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
PBPCR is an 8-bit readable/writable register that controls the MOS input pull-up function
incorporated into port B on an individual bit basis.
In modes 4 to 6, if a pin is in the input state in accordance with the settings in PFCR, in the TPU’s
TIOR, and in DDR, setting the corresponding PBPCR bit to 1 turns on the MOS input pull-up for
that pin.
In mode 7, if a pin is in the input state in accordance with the settings in the TPU’s TIOR and in
DDR, setting the corresponding PBPCR bit to 1 turns on the MOS input pull-up for that pin.
PBPCR is initialized to H'00 by a reset, and in hardware standby mode. It retains its prior state in
software standby mode.
Port B Open Drain Control Register (PBODR)
Bit
:
7
6
5
4
3
2
1
0
PB7ODR PB6ODR PB5ODR PB4ODR PB3ODR PB2ODR PB1ODR PB0ODR
Initial value :
0
0
0
0
0
0
0
0
R/W
: R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
PBODR is an 8-bit readable/writable register that controls the PMOS on/off state for each port B
pin (PB7 to PB0).
When pins are not address outputs in accordance with the setting of bits AE3 to AE0 in PFCR,
setting a PBODR bit makes the corresponding port B pin an NMOS open-drain output, while
clearing the bit to 0 makes the pin a CMOS output.
PBODR is initialized to H'00 by a reset, and in hardware standby mode. It retains its prior state in
software standby mode.
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Page 263 of 1458