HD64F2638F20J Datasheet, PDF (506/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 13 Serial Communication Interface (SCI)
H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Bit 6—Receive Interrupt Enable (RIE): Enables or disables receive data full interrupt (RXI)
request and receive error interrupt (ERI) request generation when serial receive data is transferred
from RSR to RDR and the RDRF flag in SSR is set to 1.
Bit 6
RIE
Description
0
Receive data full interrupt (RXI) request and receive error interrupt (ERI) request
disabled*
(Initial value)
1
Receive data full interrupt (RXI) request and receive error interrupt (ERI) request
enabled
Note:* RXI and ERI interrupt request cancellation can be performed by reading 1 from the RDRF
flag, or the FER, PER, or ORER flag, then clearing the flag to 0, or clearing the RIE bit to 0.
Bit 5—Transmit Enable (TE): Enables or disables the start of serial transmission by the SCI.
Bit 5
TE
Description
0
Transmission disabled^*1
1
Transmission enabled^*2
(Initial value)
Notes: 1. The TDRE flag in SSR is fixed at 1.
2. In this state, serial transmission is started when transmit data is written to TDR and the
TDRE flag in SSR is cleared to 0.
SMR setting must be performed to decide the transfer format before setting the TE bit
to 1.
Bit 4—Receive Enable (RE): Enables or disables the start of serial reception by the SCI.
Bit 4
RE
Description
0
Reception disabled^*1
1
Reception enabled^*2
(Initial value)
Notes: 1. Clearing the RE bit to 0 does not affect the RDRF, FER, PER, and ORER flags, which
retain their states.
2. Serial reception is started in this state when a start bit is detected in asynchronous
mode or serial clock input is detected in clocked synchronous mode.
SMR setting must be performed to decide the transfer format before setting the RE bit
to 1.
Page 456 of 1458
REJ09B0103-0800 Rev. 8.00
May 28, 2010