HD64F2638F20J Datasheet, PDF (327/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Section 9 I/O Ports
Port C Data Register (PCDR)
Bit
:
Initial value :
R/W
:
7
PC7DR
0
R/W
6
PC6DR
0
R/W
5
PC5DR
0
R/W
4
PC4DR
0
R/W
3
PC3DR
0
R/W
2
PC2DR
0
R/W
1
PC1DR
0
R/W
0
PC0DR
0
R/W
PCDR is an 8-bit readable/writable register that stores output data for the port C pins (PC7 to
PC0).
PCDR is initialized to H'00 by a reset, and in hardware standby mode. It retains its prior state in
software standby mode.
Port C Register (PORTC)
Bit
:
7
6
5
4
3
2
1
0
PC7
PC6
PC5
PC4
PC3
PC2
PC1
PC0
Initial value : —^*
—^*
—^*
—^*
—^*
—^*
—^*
—^*
R/W
:R
R
R
R
R
R
R
R
Note: * Determined by state of pins PC7 to PC0.
PORTC is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of
output data for the port C pins (PC7 to PC0) must always be performed on PCDR.
If a port C read is performed while PCDDR bits are set to 1, the PCDR values are read. If a port C
read is performed while PCDDR bits are cleared to 0, the pin states are read.
After a reset and in hardware standby mode, PORTC contents are determined by the pin states, as
PCDDR and PCDR are initialized. PORTC retains its prior state in software standby mode.
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Page 277 of 1458