HD64F2638F20J Datasheet, PDF (1505/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Appendix E Timing of Transition to and Recovery from Hardware Standby Mode
Appendix E Timing of Transition to and Recovery from
Hardware Standby Mode
Timing of Transition to Hardware Standby Mode
(1) To retain RAM contents with the RAME bit set to 1 in SYSCR, drive the RES signal low at
least 10 states before the STBY signal goes low, as shown below. RES must remain low until
STBY signal goes low (delay from STBY low to RES high: 0 ns or more).
STBY
RES
t₁ ≥ 10 t_cyc
t₂ ≥ 0 ns
Figure E-1 Timing of Transition to Hardware Standby Mode
(2) To retain RAM contents with the RAME bit cleared to 0 in SYSCR, or when RAM contents do
not need to be retained, RES does not have to be driven low as in (1).
Timing of Recovery from Hardware Standby Mode
Drive the RES signal low and the NMI signal high approximately 100 ns or more before STBY
goes high to execute a reset.
STBY
RES
t ≥ 100 ns
t_OSC
t_NMIRH
NMI
Figure E-2 Timing of Recovery from Hardware Standby Mode
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Page 1455 of 1458