HD64F2638F20J Datasheet, PDF (700/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 16 Controller Area Network (HCAN)
H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
16.2.20 Module Stop Control Register C (MSTPCRC)
Bit: 7
6
5
4
3
2
1
0
MSTPC7 MSTPC6 MSTPC5 MSTPC4 MSTPC3 MSTPC2^* MSTPC1 MSTPC0
Initial value: 1
1
1
1
1
1
1
1
R/W: R/W R/W R/W R/W R/W R/W R/W R/W
Note: * The MSTPC2 is not available and is reserved in the H8S/2635 Group.
MSTPCRC is an 8-bit readable/writable register that performs module stop mode control.
When the MSTPC3 and MSTPC2 bits are set to 1, HCAN0 and 1 operation is stopped at the end
of the bus cycle, and module stop mode is entered. Register read/write accesses are not possible in
module stop mode. For details, see section 23A.5, 23B.5, Module Stop Mode.
MSTPCRC is initialized to H'FF by a reset, and in hardware standby mode. It is not initialized in
software standby mode.
Bit 3—Module Stop (MSTPC3): Specifies the HCAN module stop mode.
Bit 3: MSTPC3
0
1
Description
HCAN0 module stop mode is cleared
HCAN0 module stop mode is set
(Initial value)
Bit 2—Module Stop (MSTPC2)^*: Specifies the HCAN module stop mode.
Note: * The MSTPC2 is not available and is reserved in the H8S/2635 Group.
Bit 2: MSTPC2
0
1
Description
HCAN1 module stop mode is cleared
HCAN1 module stop mode is set
(Initial value)
Page 650 of 1458
REJ09B0103-0800 Rev. 8.00
May 28, 2010