HD64F2638F20J Datasheet, PDF (339/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Section 9 I/O Ports
Port E Data Register (PEDR)
Bit
:
Initial value :
R/W
:
7
PE7DR
0
R/W
6
PE6DR
0
R/W
5
PE5DR
0
R/W
4
PE4DR
0
R/W
3
PE3DR
0
R/W
2
PE2DR
0
R/W
1
PE1DR
0
R/W
0
PE0DR
0
R/W
PEDR is an 8-bit readable/writable register that stores output data for the port E pins (PE7 to PE0).
PEDR is initialized to H'00 by a reset, and in hardware standby mode. It retains its prior state in
software standby mode.
Port E Register (PORTE)
Bit
:
7
6
5
4
3
2
1
0
PE7
PE6
PE5
PE4
PE3
PE2
PE1
PE0
Initial value : —^*
—^*
—^*
—^*
—^*
—^*
—^*
—^*
R/W
:R
R
R
R
R
R
R
R
Note: * Determined by state of pins PE7 to PE0.
PORTE is an 8-bit read-only register that shows the pin states. It cannot be written to. Writing of
output data for the port E pins (PE7 to PE0) must always be performed on PEDR.
If a port E read is performed while PEDDR bits are set to 1, the PEDR values are read. If a port E
read is performed while PEDDR bits are cleared to 0, the pin states are read.
After a reset and in hardware standby mode, PORTE contents are determined by the pin states, as
PEDDR and PEDR are initialized. PORTE retains its prior state in software standby mode.
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Page 289 of 1458