HD64F2638F20J Datasheet, PDF (894/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 21B ROM
(H8S/2638 Group, H8S/2639 Group, H8S/2630 Group)
H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
However, the RAM area overlapping flash memory space can be read and written to regardless of
whether the SWE bit is set or cleared.
Do not use interrupts while flash memory is being programmed or erased: All interrupt
requests, including NMI, should be disabled during FWE application to give priority to
program/erase operations.
Do not perform additional programming. Erase the memory before reprogramming: In on-
board programming, perform only one programming operation on a 128-byte programming unit
block. In programmer mode, too, perform only one programming operation on a 128-byte
programming unit block. Programming should be carried out with the entire programming unit
block erased.
Before programming, check that the chip is correctly mounted in the PROM programmer:
Overcurrent damage to the device can result if the index marks on the PROM programmer socket,
socket adapter, and chip are not correctly aligned.
Do not touch the socket adapter or chip during programming: Touching either of these can
cause contact faults and write errors.
Page 844 of 1458
REJ09B0103-0800 Rev. 8.00
May 28, 2010