HD64F2638F20J Datasheet, PDF (528/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 13 Serial Communication Interface (SCI)
H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Figure 13-4 shows a sample SCI initialization flowchart.
Start initialization
Clear TE and RE bits in SCR to 0
Set CKE1 and CKE0 bits in SCR
[1]
(TE, RE bits 0)
Set data transfer format in
SMR and SCMR
Set value in BRR
Wait
1-bit interval elapsed?
Yes
[2]
[3]
No
Set TE and RE bits in
SCR to 1, and set RIE, TIE, TEIE,
[4]
and MPIE bits
[1] Set the clock selection in SCR.
Be sure to clear bits RIE, TIE,
TEIE, and MPIE, and bits TE and
RE, to 0.
When the clock is selected in
asynchronous mode, it is output
immediately after SCR settings are
made.
[2] Set the data transfer format in SMR
and SCMR.
[3] Write a value corresponding to the
bit rate to BRR. Not necessary if an
external clock is used.
[4] Wait at least one bit interval, then
set the TE bit or RE bit in SCR to 1.
Also set the RIE, TIE, TEIE, and
MPIE bits.
Setting the TE and RE bits enables
the TxD and RxD pins to be used.
<Transfer completion>
Figure 13-4 Sample SCI Initialization Flowchart
Page 478 of 1458
REJ09B0103-0800 Rev. 8.00
May 28, 2010