HD64F2638F20J Datasheet, PDF (12/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Item
Page
14.4 Usage Notes 544
Retransfer Operations
(Except Block Transfer
Mode):
• Retransfer operation
when SCI is transmit
mode
15.2.9 Module Stop 575
Control Register B
(MSTPCRB)
15.3.6 Slave Transmit 594
Operation
Figure 15-18 Example
of Slave Transmit Mode
Operation Timing
(MLS = 0)
16.1.3 Pin
614
Configuration
Table 16-1 HCAN Pins
16.1.4 Register
618
Configuration
Table 16-2 HCAN
Registers
16.2.4 Mailbox
624
Configuration Register
(MBCR)
16.2.5 Transmit Wait 625
Register (TXPR)
Revision (See Manual for Details)
Note amended
Note: * The DTC is not implemented in the H8S/2635 Group.
Description amended
MSTPCRB is initialized to H'FF by a power-on reset and in
hardware standby mode. It is not initialized in software
standby mode.
Figure amended
ICDRS
Data 1
Data 2
User processing [3] IRIC [3] ICDR
clearance write
[3] ICDR
write
[5] IRIC
clearance
[5] ICDR
write
Note amended
Note: * The HCAN1 is not supported by the H8S/2635 Group.
Notes amended
Notes: 2. The HCAN1 is not supported by the H8S/2635
Group.
Table amended
Bit y: MBCRx
0
1
Description
Corresponding mailbox is set for transmission
(Initial value)
Corresponding mailbox is set for reception
(x = 15 to 1, y = 15 to 9 and 7 to 0)
Table amended
Bit y: TXPRx
0
1
Description
Transmit message idle state in corresponding mailbox
(Initial value)
[Clearing condition]
• Message transmission completion and cancellation completion
Transmit message transmit wait in corresponding mailbox (CAN bus
arbitration)
(x = 15 to 1, y = 15 to 9 and 7 to 0)
Page xii of l
REJ09B0103-0800 Rev. 8.00
May 28, 2010