HD64F2638F20J Datasheet, PDF (166/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

Section 5 Interrupt Controller
H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
5.3.2 Internal Interrupts
There are 49 sources for internal interrupts from on-chip supporting modules.
• For each on-chip supporting module there are flags that indicate the interrupt request status,
and enable bits that select enabling or disabling of these interrupts. If both of these are set to 1
for a particular interrupt source, an interrupt request is issued to the interrupt controller.
• The interrupt priority level can be set by means of IPR.
• The DTC can be activated by a TPU, SCI, or other interrupt request. When the DTC is
activated by an interrupt, the interrupt control mode and interrupt mask bits are not affected.
5.3.3 Interrupt Exception Handling Vector Table
Table 5-4 shows interrupt exception handling sources, vector addresses, and interrupt priorities.
For default priorities, the lower the vector number, the higher the priority.
Priorities among modules can be set by means of the IPR. The situation when two or more
modules are set to the same priority, and priorities within a module, are fixed as shown in
table 5-4.
Page 116 of 1458
REJ09B0103-0800 Rev. 8.00
May 28, 2010