SH7280 Datasheet, PDF (1549/1726 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine family

Section 29 User Debugging Interface (H-UDI)
29.4.4 H-UDI Reset
An H-UDI reset is executed by setting an H-UDI reset assert command in SDIR. An H-UDI reset
is of the same kind as a power-on reset. An H-UDI reset is released by setting an H-UDI reset
negate command. The required time between the H-UDI reset assert command and H-UDI reset
negate command is the same as time for keeping the RES pin low to apply a power-on reset.
SDIR
H-UDI reset assert
H-UDI reset negate
Chip internal reset
CPU state
Fetch the initial values of PC and SR from
the exception handling vector table
Figure 29.4 H-UDI Reset
29.4.5 H-UDI Interrupt
The H-UDI interrupt function generates an interrupt by setting a command from the H-UDI in
SDIR. An H-UDI interrupt is a general exception/interrupt operation, resulting in fetching the
exception service routine start address from the exception handling vector table, jumping to that
address, and starting program execution from that address. This interrupt request has a fixed
priority level of 15.
H-UDI interrupts are accepted in sleep mode, but not in software standby mode.
Rev. 1.00 Jun. 26, 2008 Page 1519 of 1692
REJ09B0393-0100