SH7280 Datasheet, PDF (1426/1726 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine family

Section 26 Flash Memory
Initial
Bit
Bit Name Value R/W Description
0
SCO
0
(R)/W Source Program Copy Operation
Requests the on-chip programming/erasing program to be
downloaded to the on-chip RAM.
When this bit is set to 1, the on-chip program which is
selected by FPCS/FECS is automatically downloaded in
the on-chip RAM area specified by FTDAR.
In order to set this bit to 1, H'A5 must be written to FKEY
and this operation must be in the on-chip RAM.
Eight NOP instructions must be executed immediately
after setting this bit to 1.
For interrupts during download, see section 26.7.2,
Interrupts during Programming/Erasing. For the download
time, see section 26.7.3, Other Notes.
Since this bit is cleared to 0 when download is completed,
this bit cannot be read as 1.
Download by setting the SCO bit to 1 requires a special
interrupt processing that performs bank switching to the
on-chip program storage area. Therefore, before issuing a
download request (SCO = 1), set VBR to H'80000000.
Otherwise, the CPU gets out of control. Once download
end is confirmed, VBR can be changed to any other value.
The mode in which the FWE pin is high must be used
when using the SCO function.
0: Download of the on-chip programming/erasing program
to the on-chip RAM is not executed.
[Clearing condition]
When download is completed
1: Request that the on-chip programming/erasing program
is downloaded to the on-chip RAM is generated
[Setting conditions]
When all of the following conditions are satisfied and 1 is
written to this bit
• FKEY is written to H'A5
• During execution in the on-chip RAM
Rev. 1.00 Jun. 26, 2008 Page 1396 of 1692
REJ09B0393-0100