SH7280 Datasheet, PDF(1095/1726 Page) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine family

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

SH7280 Datasheet, PDF (1095/1726 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine family

◁

Section 22 Controller Area Network (RCAN-ET) (SH7286 Only)

Figure 22.9 - Halt Mode / Sleep Mode shows allowed state transition.

ï£§ Please don't set MCR5 (Sleep Mode) without entering Halt Mode.

ï£§ After MCR1 is set, please don't clear it before GSR4 is set and RCAN-ET enters Halt

Mode.

Power On/SW Reset

clear MCR1

and MCR5

set MCR1*3

Reset

clear MCR0

and GSR3 = 0

Transmission

Reception

clear MCR5*1

Halt Request

clear MCR5

set MCR1*4

except Transmitter/Receiver/BusOff, if MCR6 = 0

BusOff or except Transmitter/Receiver, if MCR6 = 1

Halt Mode

set MCR5

clear MCR1*2

Sleep Mode

Figure 22.9 Halt Mode / Sleep Mode

Notes: 1. MCR5 can be cleared by automatically by detecting a dominant bit on the CAN Bus if

MCR7 is set or by writing "0"

2. MCR1 is cleared in SW. Clearing MCR1 and setting MCR5 have to be carried out by

the same instruction.

3. MCR1 must not be cleared in SW, before GSR4 is set. MCR1 can be set automatically

in HW when RCAN-ET moves to Bus Off and MCR14 and MCR6 are both set.

4. When MCR5 is cleared and MCR1 is set at the same time, RCAN-ET moves to Halt

Request. Right after that, it moves to Halt Mode with no reception/transmission.

Rev. 1.00 Jun. 26, 2008 Page 1065 of 1692

REJ09B0393-0100

▷