SH7065 Datasheet, PDF (816/941 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH RISC engine Family/SH7000 Series

Section 22 Electrical Characteristics
Usage Notes:
1. If the A/D converter is not used (including standby mode), do not leave the AV_CC and AV_SS
pins open. Connect the AV_CC pin to V_CC, and the AV_SS pin to V_SS.
2. Current dissipation values are for V_IH min = V_CC –0.5 V and V_IL max = 0.5 V with all output
pins unloaded. (For standby current specification conditions, values are for V_IH = V_CC/PV_CC
and V_IL = 0 V with all output pins unloaded.)
3. The F-ZTAT and mask ROM versions have the same functions, and the electrical
characteristics of both are within specification, but characteristic-related performance values,
operating margins, noise margins, noise emission, etc., are different. Caution is therefore
required in carrying out system design, and when switching between F-ZTAT and mask ROM
versions.
22.2.2 DC Characteristics (2)
Table 22.3 Permissible Output Current Values
Conditions: V_CC = PLLV_CC = 3.3 V ±0.3 V, PV_CC = 5.0 V ±0.5 V/3.3 V ±0.3 V, PV_CC ≥ V_CC,
AV_CC = 3.3 V ±0.3 V, V_SS = PLLV_SS = PV_SS = AV_SS = 0 V, Ta = –20°C to +75°C
Item
Symbol Min
Typ
Max
Unit
Output low-level permissible current
IOL
(per pin)
—
—
2.0^*
mA
Output low-level permissible current
(total)
∑IOL
—
—
80
mA
Output high-level permissible current
–IOH
—
—
2.0
mA
(per pin)
Output high-level permissible current
(total)
∑(–IOH)
—
—
25
mA
Note: * For PE17 to PE19 and PE21 to PE23, IOL = 15 mA (max). However, an IOL current
exceeding 2.0 mA should not be applied to more than three of these pins
simultaneously.
Usage Note: To protect chip reliability, do not exceed the output current values in table 22.3.
Rev. 5.00 Sep 11, 2006 page 794 of 916
REJ09B0332-0500