M16C65 Datasheet, PDF (495/829 Pages) Renesas Technology Corp – RENESAS MCU M16C FAMILY / M16C/60

Under development
M16C/65 Group
Preliminary Specification
This is a preliminary specification and is subject to change.
22. Remote Control Signal Receiver
22.2.13 PMC0 Compare Control Register (PMC0CPC)
PMC0 Compare Control Register
b7 b6 b5 b4 b3 b2 b1 b0
Symbol
PMC0CPC
Address
01F6h
After Reset
XXX0 X000b
Bit Symbol
Bit Name
Function
RW
CPN0
RW
CPN1
Compare bit specified bit
When the setting value is n, bits n to
0 are compared.
RW
CPN2
RW
—
(b3)
No register bit. If necessary, set to 0. Read as undefined value.
—
CPEN
Compare enable bit
0: Compare disabled
1: Compare enabled
RW
—
(b7-b5)
No register bits. If necessary, set to 0. Read as undefined value.
—
CPN2-CPN0 (Compare Bit Specified Bit) (b2-b0)
These bits are valid when the CPEN bit is 1 (compare enabled).
When the setting value of bits CPN2 to CPN0 is n, bits n to 0 are compared.
e.g.1 Setting value = 0
Bit 0 in the PMC0CPD register and bit 0 in the PMC0DAT0 register are compared.
e.g.2 Setting value = 7
Bits 7 to 0 in the PMC0CPD register and bits 7 to 0 in the PMC0DAT0 register are compared.
CPEN (Compare Enable Bit) (b4)
When the CPEN bit is 1 (compare enabled), contents of registers PMC0CPD and PMC0DAT0 are
compared.
The contents are matched, the CPFLG bit in the PMC0STS register becomes 1 (compare match).
REJ09B0484-0030 Rev.0.30 Sep 09, 2008
Page 460 of 791