M16C65 Datasheet, PDF (426/829 Pages) Renesas Technology Corp – RENESAS MCU M16C FAMILY / M16C/60

Under development
M16C/65 Group
Preliminary Specification
This is a preliminary specification and is subject to change.
19. Three-Phase Motor Control Timer Function
Table 19.13 Registers Used and Settings in Three-Phase Mode 1 (2/2)
Register
Bit
Functions, Setting Value
TRGSR
TA1TGH to
TA1TGL
01b (when using V-phase output control circuit)
TA2TGH to
TA2TGL
01b (when using W-phase output control circuit)
TA3TGH to
TA3TGL
(Not used for three-phase motor control timer.)
TA4TGH to
TA4TGL
01b (when using U-phase output control circuit)
TABSR
TA0S
Not used for three-phase motor control timer.
TA1S
Set to 1 when starting counting, and to 0 when stopping counting.
TA2S
Set to 1 when starting counting, and to 0 when stopping counting.
TA3S
Not used for three-phase motor control timer.
TA4S
Set to 1 when starting counting, and to 0 when stopping counting.
TB0S
Not used for three-phase motor control timer.
TB1S
Not used for three-phase motor control timer.
TB2S
Set to 1 when starting counting, and to 0 when stopping counting.
TA1MR,
TA2MR,
TA4MR
TMOD1 to
TMOD0
MR0
Set to 10b (one-shot timer mode).
Set to 0.
MR1
Set to 0.
MR2
1 (Select a trigger by bits TAiTGH and TAiTGL.)
MR3
Set to 0.
TCK1 to TCK0 Select a count source.
TB2MR
TMOD1 to
TMOD0
Set to 00b (timer mode).
MR1 to MR0 Set to 00b.
4
Set to 0.
MR3
Set to 0.
TCK1 to TCK0 Select a count source.
PCLKR
PCLK0
Select a count source.
TCKDIVC0 TCDIV00
Select a clock prior to timer AB division.
TACS0 to
TACS2
7 to 0
Select a count source.
TBCS1
TCS3 to TCS0 Select a count source.
TAPOFS
POFSi
Set to 0.
UDF
TAiP
Set to 0.
i = 1, 2, 4
Note:
1. This table does not show the procedures.
REJ09B0484-0030 Rev.0.30 Sep 09, 2008
Page 391 of 791