M16C65 Datasheet, PDF (167/829 Pages) Renesas Technology Corp – RENESAS MCU M16C FAMILY / M16C/60

Under development
M16C/65 Group
Preliminary Specification
This is a preliminary specification and is subject to change.
9. Power Control
9.3 Clock
The amount of current consumption correlates with the number of operating clocks and frequency. If there
are fewer operating clocks and a lower frequency, current consumption will be low.
Normal operating mode, wait mode, and stop mode are provided to control power consumption. All mode
states, except wait mode and stop mode, are called normal operating mode in this document.
9.3.1 Normal Operating Mode
In normal operating mode, because both the CPU clock and the peripheral function clocks are
supplied, the CPU and the peripheral functions are operating. Power control is exercised by
controlling the CPU clock frequency. The higher the CPU clock frequency, the greater the processing
capability. The lower the CPU clock frequency, the smaller the power consumption in the chip. If
unnecessary oscillator circuits are turned off, power consumption is further reduced.
9.3.1.1 High-Speed Mode and Medium-Speed Mode
In high-speed mode, the main clock divided by 1 (no division) is used as the CPU clock.
In medium-speed mode, the main clock divided by 2, 4, 8 or 16 is used as the CPU clock.
f1 with the same frequency of the main clock divided by 1 is used as the peripheral function
clocks in both high-speed and medium-speed modes. When fC is supplied, fC and fC32 can
be used as the peripheral function clocks. When fOCO-S is supplied, it can be used as the
peripheral function clocks. When fOCO40M and fOCO-F are supplied, they can be used as the
peripheral function clocks.
9.3.1.2 PLL Operating Mode
The PLL clock divided by 1 (no division), 2, 4, 8 or 16 is used as the CPU clock. f1 with the same
frequency of the PLL clock divided by 1 (no division) is used as the peripheral function clocks.
When fC is supplied, fC and fC32 can be used as the peripheral function clocks. When fOCO-S is
supplied, it can be used as the peripheral function clocks. When fOCO40M and fOCO-F are supplied,
they can be used as the peripheral function clocks.
PLL operating mode can be entered and exited from high-speed mode or medium-speed mode. To
enter other modes including wait mode and stop mode, enter high-speed mode or medium-speed
mode first, and then enter the intended mode (refer to Figure 9.1 “Clock Mode Transition”).
9.3.1.3 40 MHz On-Chip Oscillator Mode
The fOCO-F clock divided by 1 (no division), 2, 4, 8 or 16 is used as the CPU clock. f1 with the same
frequency of the fOCO-F clock divided by 1 is used as the peripheral function clocks.
When fC is supplied, fC and fC32 can be used as the peripheral function clocks. When fOCO-S is
supplied, it can be used as the peripheral function clocks. fOCO40M and fOCO-F can be used as the
peripheral function clocks.
REJ09B0484-0030 Rev.0.30 Sep 09, 2008
Page 132 of 791