M16C65 Datasheet, PDF (40/829 Pages) Renesas Technology Corp – RENESAS MCU M16C FAMILY / M16C/60

Under development
M16C/65 Group
Preliminary Specification
This is a preliminary specification and is subject to change.
1. Overview
Table 1.4 Specifications (100-Pin Package) (2/2)
Item
Function
Specification
Timer
Timer A
16-bit timer × 5
Timer mode, event counter mode, one-shot timer mode, pulse width
modulation (PWM) mode
Event counter two-phase pulse signal processing (two-phase encoder
input) × 3
Programmable output mode × 3
Timer B
16-bit timer × 6
Timer mode, event counter mode, pulse period measurement mode,
pulse width measurement mode
Three-phase motor control
timer function
Three-phase inverter control (timer A1, timer A2, timer A4, timer B2),
on-chip dead time timer
Real-time clock
Count: second, minute, hour, day of week
PWM function
8 bits × 2
Remote control signal receiver
• 2 circuits
• 4 wave pattern matchings (differentiate wave pattern for headers, data
0, data 1, and special data)
• 6-byte receive buffer (1 circuit)
• Operating frequency of 32 kHz
Serial
Interface
UART0 to UART2, UART5 to
UART7
Clock synchronous/asynchronous × 6 channels
I²C-bus, IEBus ⁽¹⁾, special mode 2
SIM (UART2)
SI/O3, SI/O4
Clock synchronization only × 2 channels
Multi-master I²C bus interface ^{1 channel}
CEC function ⁽³⁾
CEC transmit/receive, arbitration lost detection, ACK signal generation,
operation frequency of 32 kHz
A/D Converter
10-bit resolution × 26 channels, including sample and hold function
Conversion time: 1.72 µs
D/A Converter
8-bit resolution × 2
CRC Calculator
CRC-CCITT (X¹⁶ + X¹² + X⁵ + 1),
CRC-16 (X¹⁶ + X¹⁵ + X² + 1) compliant
Flash Memory
Programming and erasure power supply voltage: 2.7 to 5.5 V
Programming and erasure endurance: 1,000 times (program ROM 1,
program ROM 2)/10,000 times (data flash)
Program security: ROM code protect, ID code check
Debug Function
Functions on-chip debug, on-board flash rewrite function, address
match × 4
Operation Frequency/Supply Voltage
25 MHz/VCC1 = 2.7 to 5.5 V, VCC2 = 2.7 V to VCC132 MHz/VCC1 =
3.0 to 5.5 V, VCC2 = 2.7 V to VCC1
Current Consumption
TBD (32 MHz/VCC1 = VCC2 = 3 V)
TBD (VCC1 = VCC2 = 3 V, in stop mode)
Operating Temperature
-20°C to 85°C, -40°C to 85°C ⁽²⁾
Package
100-pin QFP: PRQP0100JD-B (Previous package code: 100P6F-A)
100-pin LQFP: PLQP0100KB-A (Previous package code: 100P6Q-A)
Notes:
1. IEBus is a registered trademark of NEC Electronics Corporation.
2. See Table 1.7 “Product List” for the operating temperature.
3. The CEC function indicates circuitry which supports the transmission and reception of CEC signals standardized
by the High-Definition Multimedia Interface (HDMI). HDMI and High-Definition Multimedia Interface are
registered trademarks of HDMI Licensing, LLC.
REJ09B0484-0030 Rev.0.30 Sep 09, 2008
Page 5 of 791