SH7615 Datasheet, PDF (178/925 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH
RISC engine Family/SH7600 Series

4.6.3 Instructions in Repeat Loops
If a repeat loop comprises up to three instructions, neither exceptions nor interrupts are accepted.
If a repeat loop contains four or more instructions, neither exceptions nor interrupts are accepted
during the execution cycle of the first instruction or the last three instructions. If a repeat loop
contains four or more instructions, address errors only are accepted during the execution cycle of
the fourth from last instruction. For more information, see the SH-1/SH-2/SH-DSP Programming
Manual.
A. All interrupts and address errors are accepted.
B. Address errors only are accepted.
C. No interrupts or address errors are accepted.
When RC ≥ 1
(1) One instruction
←A
instr0 _{← B}
Start (End): instr1 _{← C}
instr2 _{← A}
(2) Two instructions
←A
instr0 _{← B}
Start: instr1 _{← C}
End: instr2 _{← C}
instr3
←
A
(4) Four or more instructions
←A
instr0
← A or C (on return from instr n)
Start:instr1 _{← A}
:
:
:
←A
instr n-3 _{← B}
instr n-2 _{← C}
instr n-1 _{← C}
End: instr n _{← C}
instr
n+1
←
A
(3) Three instructions
←A
instr0 _{← B}
Start: instr1 _{← C}
instr2 _{← C}
End:
instr3
←
C
instr4
←A
When RC = 0
All interrupts and address errors are accepted.
Figure 4.1 Interrupt Acceptance Restrictions in Repeat Mode
Rev. 2.00, 03/05, page 140 of 884