HC4GX15 Datasheet, PDF (178/668 Pages) Altera Corporation – HardCopy IV Device Handbook

1–10
Chapter 1: HardCopy IV Design Flow Using the Quartus II Software
Quartus II Settings for HardCopy IV Devices
Figure 1–3. Limit DSP and RAM to HardCopy IV Device Resources Checkbox
1 The Altera HardCopy Design Center requires that your final Stratix IV and
HardCopy IV designs be compiled with the Limit DSP & RAM to HardCopy device
resources setting turned on before submission to the Altera HardCopy Design Center
for back-end implementation.
Enable Design Assistant to Run During Compile
You must use the Quartus II Design Assistant to check for design rule violations
before submitting the designs to the Altera HardCopy Design Center. Additionally,
you must fix all critical and high-level errors reported by the Quartus II Design
Assistant. Altera recommends turning on the Design Assistant to run automatically
during development.
To enable the Design Assistant to run during compilation, on the Assignments menu,
click Settings. In the Category list, select Design Assistant and turn on Run Design
Assistant during compilation.
HardCopy IV Device Handbook, Volume 2
© January 2010 Altera Corporation