HD64F2149 Datasheet, PDF (233/1035 Pages) Renesas Technology Corp – Hitachi 16-Bit Single-Chip Microcomputer

Modes 2 and 3 (EXPE = 0): In modes 2 and 3 (when EXPE = 0), port 1 pins function as PWM
outputs or I/O ports, and input or output can be specified on a bit-by-bit basis. When a bit in
P1DDR is set to 1, the corresponding pin functions as a PWM output or output port, and when
cleared to 0, as an input port.
The port 1 pin functions are shown in figure 8.4.
Port 1
P1n: Input pin when P1DDR = 0,
output pin when P1DDR = 1
and PWOERA = 0
P17 (I/O)
P16 (I/O)
P15 (I/O)
P14 (I/O)
P13 (I/O)
P12 (I/O)
P11 (I/O)
P10 (I/O)
When P1DDR = 1
and PWOERA = 1
PW7 (Output)
PW6 (Output)
PW5 (Output)
PW4 (Output)
PW3 (Output)
PW2 (Output)
PW1 (Output)
PW0 (Output)
Figure 8.4 Port 1 Pin Functions (Modes 2 and 3 (EXPE = 0))
8.2.4 MOS Input Pull-Up Function
Port 1 has a built-in MOS input pull-up function that can be controlled by software. This MOS
input pull-up function can be used in modes 2 and 3, and can be specified as on or off on a bit-by-
bit basis.
When a P1DDR bit is cleared to 0 in mode 2 or 3, setting the corresponding P1PCR bit to 1 turns
on the MOS input pull-up for that pin.
The MOS input pull-up function is in the off state after a reset and in hardware standby mode. The
prior state is retained in software standby mode.
Table 8.4 summarizes the MOS input pull-up states.
199