HD64F2149 Datasheet, PDF (207/1035 Pages) Renesas Technology Corp – Hitachi 16-Bit Single-Chip Microcomputer

7.3.2 Activation Sources
The DTC operates when activated by an interrupt or by a write to DTVECR by software (software
activation). An interrupt request can be directed to the CPU or DTC, as designated by the
corresponding DTCER bit. The interrupt request is directed to the DTC when the corresponding
bit is set to 1, and to the CPU when the bit is cleared to 0.
At the end of one data transfer (or the last of the consecutive transfers in the case of chain transfer)
the interrupt source or the corresponding DTCER bit is cleared. Table 7.3 shows activation
sources and DTCER clearing.
The interrupt source flag for RXI0, for example, is the RDRF flag in SCI0.
Table 7.3 Activation Sources and DTCER Clearing
Activation
Source
Software
activation
Interrupt
activation
When DISEL Bit Is 0 and
Specified Number of Transfers
Have Not Ended
SWDTE bit cleared to 0
• Corresponding DTCER bit
held at 1
• Activation source flag cleared
to 0
When DISEL Bit Is 1 or
Specified Number of Transfers
Have Ended
• SWDTE bit held at 1
• Interrupt request sent to CPU
• Corresponding DTCER bit cleared
to 0
• Activation source flag held at 1
• Activation source interrupt request
sent to CPU
Figure 7.3 shows a block diagram of activation source control. For details see section 5, Interrupt
Controller.
173