HD6417750RF240DV Datasheet, PDF (913/1132 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7750 Series

SH7750, SH7750S, SH7750R Group
Section 20 User Break Controller (UBC)
Bits 31 to 0—Break Data Mask B31 to B0 (BDMB31–BDMB0): These bits specify whether the
corresponding bit of the channel B break data B31 to B0 (BDB31–BDB0) set in BDRB is to be
masked.
Bit 31–0: BDMBn Description
0
Channel B break data bit BDBn is included in break conditions
1
Channel B break data bit BDBn is masked, and not included in break
conditions
Note:
n = 31 to 0
When the data bus value is included in the break conditions, the operand size should be
specified. When byte size is specified, set the same data in bits 15–8 and 7–0 of BDRB and
BDMRB.
20.2.11 Break Bus Cycle Register B (BBRB)
BBRB is the channel B bus break register. The bit configuration is the same as for BBRA.
20.2.12 Break Control Register (BRCR)
Bit: 15
14
13
12
11
10
9
8
CMFA CMFB —
—
— PCBA —
—
Initial value: 0
0
0
0
0
*
0
0
R/W: R/W R/W
R
R
R
R/W
R
R
Bit: 7
6
5
DBEB PCBB —
Initial value: *
*
0
R/W: R/W R/W
R
Legend: *: Undefined
4
3
2
—
SEQ
—
0
*
0
R
R/W
R
1
0
— UBDE
0
0
R
R/W
The break control register (BRCR) is a 16-bit readable/writable register that specifies (1) whether
channels A and B are to be used as two independent channels or in a sequential condition, (2)
whether the break is to be effected before or after instruction execution, (3) whether the BDRB
register is to be included in the channel B break conditions, and (4) whether the user break debug
function is to be used. BRCR also contains condition match flags. The CMFA, CMFB, and UBDE
bits in BRCR are initialized to 0 by a power-on reset, but retain their value in standby mode. The
value of the PCBA, DBEB, PCBB, and SEQ bits is undefined after a power-on reset or manual
reset, so these bits should be initialized by software as necessary.
R01UH0456EJ0702 Rev. 7.02
Sep 24, 2013
Page 861 of 1076