HD6417750RF240DV Datasheet, PDF (786/1132 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7750 Series

Section 16 Serial Communication Interface with FIFO (SCIF)
SH7750, SH7750S, SH7750R Group
16.2.6 Serial Control Register (SCSCR2)
Bit: 15
14
13
12
11
10
9
8
—
—
—
—
—
—
—
—
Initial value: 0
0
0
0
0
0
0
0
R/W: R
R
R
R
R
R
R
R
Bit: 7
6
5
4
3
2
1
0
TIE
RIE
TE
RE REIE
—
CKE1
—
Initial value: 0
0
0
0
0
0
0
0
R/W: R/W R/W R/W R/W R/W
R
R/W
R
The SCSCR2 register performs enabling or disabling of SCIF transfer operations, and interrupt
requests, and selection of the serial clock source.
SCSCR2 can be read or written to by the CPU at all times.
SCSCR2 is initialized to H'0000 by a power-on reset or manual reset. It is not initialized in
standby mode or in the module standby state.
Bits 15 to 8, 2, and 0—Reserved: These bits are always read as 0, and should only be written
with 0.
Bit 7—Transmit Interrupt Enable (TIE): Enables or disables transmit-FIFO-data-empty
interrupt (TXI) request generation when serial transmit data is transferred from SCFTDR2 to
SCTSR2, the number of data bytes in the transmit FIFO register falls to or below the transmit
trigger set number, and the TDFE flag in the serial status register (SCFSR2) is set to 1.
Bit 7: TIE
Description
0
Transmit-FIFO-data-empty interrupt (TXI) request disabled* (Initial value)
1
Transmit-FIFO-data-empty interrupt (TXI) request enabled
Note: * TXI interrupt requests can be cleared by writing transmit data exceeding the transmit
trigger set number to SCFTDR2 after reading 1 from the TDFE flag, then clearing it to 0,
or by clearing the TIE bit to 0.
Page 734 of 1076
R01UH0456EJ0702 Rev. 7.02
Sep 24, 2013