HD6417750RF240DV Datasheet, PDF (314/1132 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7750 Series

Section 9 Power-Down Modes
SH7750, SH7750S, SH7750R Group
9.2 Register Descriptions
9.2.1 Standby Control Register (STBCR)
The standby control register (STBCR) is an 8-bit readable/writable register that specifies the
power-down mode status. It is initialized to H'00 by a power-on reset via the RESET pin or due to
watchdog timer overflow.
Bit:
Initial value:
R/W:
7
STBY
0
R/W
6
PHZ
0
R/W
5
PPU
0
R/W
4
3
2
1
0
MSTP4 MSTP3 MSTP2 MSTP1 MSTP0
0
0
0
0
0
R/W R/W R/W R/W R/W
Bit 7—Standby (STBY): Specifies a transition to standby mode.
Bit 7: STBY
0
1
Description
Transition to sleep mode on execution of SLEEP instruction (Initial value)
Transition to standby mode on execution of SLEEP instruction
Bit 6—Peripheral Module Pin High Impedance Control (PHZ): Controls the state of
peripheral module related pins in standby mode. When the PHZ bit is set to 1, peripheral module
related pins go to the high-impedance state in standby mode.
For the relevant pins, see section 9.2.2, Peripheral Module Pin High Impedance Control.
Bit 6: PHZ
0
1
Description
Peripheral module related pins are in normal state
Peripheral module related pins go to high-impedance state
(Initial value)
Bit 5—Peripheral Module Pin Pull-Up Control (PPU): Controls the state of peripheral module
related pins. When the PPU bit is cleared to 0, the pull-up resistor is turned on for peripheral
module related pins in the input or high-impedance state.
For the relevant pins, see section 9.2.3, Peripheral Module Pin Pull-Up Control.
Bit 5: PPU
0
1
Description
Peripheral module related pin pull-up resistors are on
Peripheral module related pin pull-up resistors are off
(Initial value)
Page 262 of 1076
R01UH0456EJ0702 Rev. 7.02
Sep 24, 2013