HD6417750RF240DV Datasheet, PDF (183/1132 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7750 Series

SH7750, SH7750S, SH7750R Group
Section 4 Caches
4.4.3 IC Index Mode
Setting CCR.IIX to 1 enables IC indexing to be performed using bit [25] of the effective address.
This is called IC index mode. In normal mode, with CCR.IIX cleared to 0, IC indexing is
performed using bits [12:5] of the effective address. Using index mode allows the IC to be handled
as two areas by means of effective address bit [25], providing efficient use of the cache.
4.5 Memory-Mapped Cache Configuration (SH7750, SH7750S)
To enable the IC and OC to be managed by software, their contents can be read and written by a
P2 area program with a MOV instruction in privileged mode. Operation is not guaranteed if access
is made from a program in another area. In this case, a branch to the P0, U0, P1, or P3 area should
be made at least 8 instructions after this MOV instruction. The IC and OC are allocated to the P4
area in physical memory space. Only data accesses can be used on both the IC address array and
data array and the OC address array and data array, and accesses are always longword-size.
Instruction fetches cannot be performed in these areas. For reserved bits, a write value of 0 should
be specified; their read value is undefined.
4.5.1 IC Address Array
The IC address array is allocated to addresses H'F000 0000 to H'F0FF FFFF in the P4 area. An
address array access requires a 32-bit address field specification (when reading or writing) and a
32-bit data field specification. The entry to be accessed is specified in the address field, and the
write tag and V bit are specified in the data field.
In the address field, bits [31:24] have the value H'F0 indicating the IC address array, and the entry
is specified by bits [12:5]. CCR.IIX has no effect on this entry specification. The address array bit
[3] association bit (A bit) specifies whether or not association is performed when writing to the IC
address array. As only longword access is used, 0 should be specified for address field bits [1:0].
In the data field, the tag is indicated by bits [31:10], and the V bit by bit [0]. As the IC address
array tag is 19 bits in length, data field bits [31:29] are not used in the case of a write in which
association is not performed. Data field bits [31:29] are used for the virtual address specification
only in the case of a write in which association is performed.
The following three kinds of operation can be used on the IC address array:
1. IC address array read
The tag and V bit are read into the data field from the IC entry corresponding to the entry set in
the address field. In a read, associative operation is not performed regardless of whether the
association bit specified in the address field is 1 or 0.
R01UH0456EJ0702 Rev. 7.02
Sep 24, 2013
Page 131 of 1076