HD6417750RF240DV Datasheet, PDF (686/1132 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperH™ RISC engine Family / SH7750 Series

Section 14 Direct Memory Access Controller (DMAC)
SH7750, SH7750S, SH7750R Group
11. Clearing DDT mode
Check that DMA transfer is not in progress on any channel before setting the DMAOR.DDT
bit. If the DMAOR.DDT setting is changed from 1 to 0 during DMA transfer in DDT mode,
the DMAC will freeze.
This also applies when switching from normal DMA mode (DMAOR.DDT = 0) to DDT
mode.
12. Confirming DMA transfer requests and number of transfers executed
The channel associated with a DMA bus cycle being executed in response to a DMA transfer
request can be confirmed by determining the level of external pins ID1 and ID0 at the rising
edge of the CKIO clock while TDACK is asserted.
(ID = 00: channel 0; ID = 01: channel 1; ID = 10: channel 2; ID = 11: channel 3)
14.6 Configuration of the DMAC (SH7750R)
14.6.1 Block Diagram of the DMAC
Figure 14.53 is a block diagram of the DMAC in the SH7750R.
Page 634 of 1076
R01UH0456EJ0702 Rev. 7.02
Sep 24, 2013