82801FB Datasheet, PDF (143/786 Pages) Intel Corporation – Intel I/O Controller Hub 6 (ICH6) Family

Functional Description
5.11.4
Specific Interrupts Not Supported via SERIRQ
There are three interrupts seen through the serial stream that are not supported by the ICH6. These
interrupts are generated internally, and are not sharable with other devices within the system. These
interrupts are:
• IRQ0. Heartbeat interrupt generated off of the internal 8254 counter 0.
• IRQ8#. RTC interrupt can only be generated internally.
• IRQ13. Floating point error interrupt generated off of the processor assertion of FERR#.
The ICH6 ignores the state of these interrupts in the serial stream, and does not adjust their level
based on the level seen in the serial stream.
5.11.5 Data Frame Format
Table 5-19 shows the format of the data frames. For the PCI interrupts (A–D), the output from the
ICH6 is ANDed with the PCI input signal. This way, the interrupt can be signaled via both the PCI
interrupt input signal and via the SERIRQ signal (they are shared).
Table 5-19. Data Frame Format
Data
Frame #
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Interrupt
IRQ0
IRQ1
SMI#
IRQ3
IRQ4
IRQ5
IRQ6
IRQ7
IRQ8
IRQ9
IRQ10
IRQ11
IRQ12
IRQ13
IRQ14
IRQ15
IOCHCK#
PCI INTA#
PCI INTB#
PCI INTC#
PCI INTD#
Clocks Past
Start Frame
Comment
2
Ignored. IRQ0 can only be generated via the internal 8524
5
8
Causes SMI# if low. Will set the SERIRQ_SMI_STS bit.
11
14
17
20
23
26
Ignored. IRQ8# can only be generated internally.
29
32
35
38
41
Ignored. IRQ13 can only be generated from FERR#
44
Not attached to PATA or SATA logic
47
Not attached to PATA or SATA logic
50
Same as ISA IOCHCK# going active.
53
Drive PIRQA#
56
Drive PIRQB#
59
Drive PIRQC#
62
Drive PIRQD#
Intel^® I/O Controller Hub 6 (ICH6) Family Datasheet
143