SH7713 Datasheet, PDF (251/904 Pages) Renesas Technology Corp – Renesas 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7700 Series

Section 5 Memory Management Unit (MMU)
5.6 Memory-Mapped TLB
In order for TLB operations to be managed by software, TLB contents can be read or written to in
the privileged mode using the MOV instruction. The TLB is assigned to the P4 area in the virtual
address space. The TLB address array (VPN, V bit, and ASID) is assigned to H'F2000000 to
H'F2FFFFFF, and the data array (PPN, PR, SZ, C, D, and SH bits) to H'F3000000 to
H'F3FFFFFF. The V bit in the address array can also be accessed from the data array. Only
longword access is possible for both the address array and the data array. However, the instruction
data cannot be fetched from both arrays.
5.6.1 Address Array
The address array is assigned to H'F2000000 to H'F2FFFFFF. To access an address array, the 32-
bit address field (for read/write operations) and 32-bit data field (for write operations) must be
specified. The address field specifies information for selecting the entry to be accessed; the data
field specifies the VPN, V bit and ASID to be written to the address array (figure 5.14 (1)).
In the address field, specify the entry address for selecting the entry (bits 16 to 12), W for
selecting the way (bits 9 to 8) and H'F2 to indicate address array access (bits 31 to 24). The IX bit
in MMUCR indicates whether an EX-OR is taken of the entry address and ASID.
The following two operations can be used on the address array:
1. Address array read
VPN, V, and ASID are read from the TLB entry corresponding to the entry address and way
set in the address field.
2. TLB address array write
The data specified in the data field are written to the TLB entry corresponding to the entry
address and way set in the address field.
5.6.2 Data Array
The data array is assigned to H'F3000000 to H'F3FFFFFF. To access a data array, the 32-bit
address field (for read/write operations), and 32-bit data field (for write operations) must be
specified. The address section specifies information for selecting the entry to be accessed; the data
section specifies the longword data to be written to the data array (figure 5.14 (2)).
In the address section, specify the entry address for selecting the entry (bits 16 to 12), W for
selecting the way (bits 9 to 8), and H'F3 to indicate data array access (bits 31 to 24). The IX bit in
MMUCR indicates whether an EX-OR is taken of the entry address and ASID.
Rev.1.50 Aug. 30, 2006 Page 211 of 860
REJ09B0288-0150