SH7616 Datasheet, PDF (330/935 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH™ RISC engine Family/SH7600 Series

Section 7 Bus State Controller (BSC)
CKIO
Tr
Tc
Trwl
Tap
A24–A11
A10
A9–A1
CS2 or CS3
RAS
CAS
RD/WR
DQMxx
D31–D0
DACKn*
Note: * DACKn waveform when active-low is specified.
Figure 7.25 Basic Single Write Cycle Timing (Auto-Precharge)
7.5.6 Burst Write Mode
Burst write mode can be selected by setting the BWE bit to 1 in BCR3. The basic timing charts for
burst write access is shown in figure 7.26 (a) and (b). This example assumes a 32-bit bus width
and a burst length of 4. In the burst write cycle, the WRITA command that performs auto-
precharge is issued in Tc1 following the ACTV command Tr cycle. The first 4 bytes of write data
are output simultaneously with the WRITA command in Tc1, and the remaining 12 bytes of data
are output consecutively in Tc2, Tc3, and Tc4. In a write with auto-precharge, as with a single
write, a Trw1 cycle that provides the waiting time until precharge is started is inserted after output
of the write data, followed by a Tap cycle for the precharge wait in a write access. The Trw1 and
Rev. 2.00 Mar 09, 2006 page 304 of 906
REJ09B0292-0200