HD6417751 Datasheet, PDF (562/1105 Pages) Renesas Technology Corp – SuperH RISC engine

14.5.2 Pins in DDT Mode
Figure 14.24 shows the system configuration in DDT mode.
SH7751 Series
/
/DRAK0
/
/DACK0
ID1, ID0/DRAK1, DACK1
CLK
D31–D0 = DTR
External device
A25–A0, RAS, CAS, WE, DQMn, CKE
Synchronous
DRAM
Figure 14.24 System Configuration in On-Demand Data Transfer Mode
• #": Data bus release request signal for transmitting the data transfer request format (DTR
format) or a DMA request from an external device to the DMAC
If there is a wait for release of the data bus, an external device can have the data bus released
by asserting '%5(4. When '%5(4 is accepted, the BSC asserts %$9/.
• %$9/: Data bus D31–D0 release signal
Assertion of %$9/ means that the data bus will be released two cycles later.
• 75: Transfer request signal
Assertion of 75 has the following different meanings.
 In normal data transfer mode (except channel 0), 75 is asserted, and at the same time the
DTR format is output, two cycles after %$9/ is asserted.
 In the case of the handshake protocol without use of the data bus, asserting 75 enables a
transfer request to be issued for the channel for which a transfer request was made
immediately before. This function can be used only when %$9/ is not asserted two cycles
earlier.
 In the case of direct data transfer mode (valid only for channel 2), a direct transfer request
can be made to channel 2 by asserting '%5(4 and 75 simultaneously.
Rev. 3.0, 04/02, page 522 of 1064