HD6417751 Datasheet, PDF (424/1105 Pages) Renesas Technology Corp – SuperH RISC engine

CKIO
Address
RD/
Tr1 Tr2 Tc1 Tc2 Tc1 Tc2 Tc1 Tc2 Tc1 Tc2 Tce Tpc
Row
c1
c2
c8
D31–D0
(read)
d1
d2
d8
DACKn
(SA: IO ← memory)
Note: For DACKn, an example is shown where CHCRn.AL (access level) = 0 for the DMAC.
Figure 13.18 Burst Access Timing in DRAM EDO Mode
RAS Down Mode: The SH7751 Series has an address comparator for detecting row address
matches in burst mode. By using this address comparator, and also setting RAS down mode
specification bit RASD to 1, it is possible to select RAS down mode, in which 5$6 remains
asserted after the end of an access. When RAS down mode is used, if the refresh cycle is longer
than the maximum DRAM 5$6 assert time, the refresh cycle must be decreased to or below the
maximum value of t_RAS.
In RAS down mode, in the event of an access to an address with a different row address, an access
to a different area, a refresh request, or a bus release request, 5$6 is negated and the necessary
operation is performed. When DRAM access is resumed after this, since this is the start of RAS
down mode, the operation starts with row address output. Timing charts are shown in figures
13.19 (1), (2), (3), and (4).
Rev. 3.0, 04/02, page 384 of 1064