SH7040 Datasheet, PDF (785/923 Pages) Renesas Technology Corp – Renesas 32-Bit Single-Chip RISC Microprocessor SuperH RISC engine Family/SH7040 Series(CPU Core SH-2)

Table 24.3 Register States in the Standby Mode (cont)
Module
Pin function controller
(PFC)
I/O port (I/O)
Power-down state
related
Registers Initialized
—
—
—
Registers that
Retain Data
All registers
Registers with
Undefined Contents
—
All registers
—
Standby control —
register (SBYCR)
24.4.2 Canceling the Standby Mode
The standby mode is canceled by an NMI interrupt, a power-on reset, or a manual reset.
Cancellation by an NMI: Clock oscillation starts when a rising edge or falling edge (selected by
the NMI edge select bit (NMIE) of the interrupt control register (ICR) of the INTC) is detected in
the NMI signal. This clock is supplied only to the watchdog timer (WDT). A WDT overflow
occurs if the time established by the clock select bits (CKS2–CKS0) in the TCSR of the WDT
elapses before transition to the standby mode. The occurrence of this overflow is used to indicate
that the clock has stabilized, so the clock is supplied to the entire chip, the standby mode is
canceled, and NMI exception processing begins.
When canceling standby mode with NMI interrupts, set the CKS2–CKS0 bits so that the WDT
overflow period is longer than the oscillation stabilization time.
When canceling standby mode with an NMI pin set for falling edge, be sure that the NMI pin level
upon entering standby (when the clock is halted) is high level, and that the NMI pin level upon
returning from standby (when the clock starts after oscillation stabilization) is low level. When
canceling standby mode with an NMI pin set for rising edge, be sure that the NMI pin level upon
entering standby (when the clock is halted) is low level, and that the NMI pin level upon returning
from standby (when the clock starts after oscillation stabilization) is high level.
Cancellation by a Power-On Reset: A power-on reset caused by setting the RES pin to low level
cancels the standby mode.
747