|
SH7040 Datasheet, PDF (485/923 Pages) Renesas Technology Corp – Renesas 32-Bit Single-Chip RISC Microprocessor SuperH RISC engine Family/SH7040 Series(CPU Core SH-2) | |||
|
◁ |
⢠Bit 13âPOE1 Flag (POE1F): This flag indicates that a high impedance request has been input
to the POE1 pin.
Bit 13: POE1F
0
1
Description
Clear condition: By writing 0 to POE1F after reading a POE1F = 1
(initial value)
Set condition: When the input set by ICSR bits 3 and 2 occurs at
the POE1 pin
⢠Bit 12âPOE0 Flag (POE0F): This flag indicates that a high impedance request has been input
to the POE0 pin.
Bit 12: POE0F
0
1
Description
Clear condition: By writing 0 to POE0F after reading a POE0F = 1
(initial value)
Set condition: When the input set by ICSR bits 1 and 0 occurs at
the POE0 pin
⢠Bits 11â9âReserved: These bits always read as 0. The write value should always be 0.
⢠Bit 8âPort Interrupt Enable (PIE): Enables or disables interrupt requests when any of the
POE0FâPOE3F bits of the ICSR are set to 1.
Bit 8: PIE
0
1
Description
Interrupt requests disabled (initial value)
Interrupt requests enabled
⢠Bits 7 and 6âPOE3 Mode 1, 0 (POE3M1 and POE3M0): These bits select the input mode of
the POE3 pin.
Bit 7:
POE3M1
0
1
Bit 6:
POE3M0
0
1
0
1
Description
Accept request on falling edge of POE3 input. (initial value)
Accept request when POE3 input has been sampled for 16
Ï/8 clock pulses, and all are low level.
Accept request when POE3 input has been sampled for 16
Ï/16 clock pulses, and all are low level.
Accept request when POE3 input has been sampled for 16
Ï/128 clock pulses, and all are low level.
447
|
▷ |