SH7040 Datasheet, PDF (285/923 Pages) Renesas Technology Corp – Renesas 32-Bit Single-Chip RISC Microprocessor SuperH RISC engine Family/SH7040 Series(CPU Core SH-2)

DRAK is output once for the first DREQ sampling, irrespective of transfer mode or DREQ
detection method. In burst mode, using edge detection, DREQ is sampled for the first cycle only,
so DRAK is also output for the first cycle only. Therefore, the DREQ signal negate timing can be
ascertained, and this facilitates handshake operations of transfer requests with the DMAC.
Cycle Steal Mode Operations: In cycle steal mode, DREQ sampling timing is the same
irrespective of dual or single address mode, or whether edge or low-level DREQ detection is used.
For example, DMAC transfer begins (figure 11.15), at the earliest, three cycles from the first
sampling timing. The second sampling begins at the start of the transfer one bus cycle prior to the
start of the DMAC transfer initiated by the first sampling (i.e., from the start of the CPU(3)
transfer). At this point, if DREQ detection has not occurred, sampling is executed every cycle
thereafter.
As in figure 11.16, whatever cycle the CPU transfer cycle is, the next sampling begins from the
start of the transfer one bus cycle before the DMAC transfer begins.
Figure 11.15 shows an example of output during DACK read and figure 11.16 an example of
output during DACK write.
247