SH7751 Datasheet, PDF (755/1224 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer

Initialization
Clear TE and RE bits
in SCSCR1 to 0
Set RIE, TIE, TEIE, MPIE, CKE1
and CKE0 bits in SCSCR1
(leaving TE and RE bits
cleared to 0)
Set data transfer format
in SCSMR1
Set value in SCBRR1
Wait
1-bit interval elapsed?
No
Yes
Set TE and RE bits in SCSCR1
to 1, and set RIE, TIE, TEIE,
and MPIE bits
15. Serial Communication Interface (SCI)
1. Set the clock selection in SCSCR1.
Be sure to clear bits RIE, TIE, TEIE,
and MPIE, TE and RE, to 0.
2. Set the data transfer format in
SCSMR1.
3. Write a value corresponding to the bit
rate into SCBRR1. (Not necessary if
an external clock is used.)
4. Wait at least one bit interval, then set
the TE bit or RE bit in SCSCR1 to 1.
Also set the RIE, TIE, TEIE, and MPIE
bits. Setting the TE and RE bits
enables the TxD and RxD pins to be
used.
End
Figure 15.19 Sample SCI Initialization Flowchart
Rev.4.00 Oct. 10, 2008 Page 657 of 1122
REJ09B0370-0400