SH7050 Datasheet, PDF (623/841 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH RISC engine Family/

Section 19 ROM (256 kB Version)
19.5.5 RAM Emulation Register (RAMER)
RAMER specifies the area of flash memory to be overlapped with part of RAM when emulating
real-time flash memory programming. RAMER is initialized to H'0000 by a reset and in hardware
standby mode. It is not initialized in software standby mode. RAMER settings should be made in
user mode or user program mode. (For details, see the description of the BSC.)
Flash memory area divisions are shown in table 19.4. To ensure correct operation of the emulation
function, the ROM for which RAM emulation is performed should not be accessed immediately
after this register has been modified. Normal execution of an access immediately after register
modification is not guaranteed.
Bit: 15
14
13
12
11
10
9
8
—
—
—
—
—
—
—
—
Initial value: 0
0
0
0
0
0
0
0
R/W: R
R
R
R
R
R
R
R
Bit: 7
6
5
4
3
2
1
0
—
—
—
—
— RAMS RAM1 RAM0
Initial value: 0
0
0
0
0
0
0
0
R/W: R
R
R
R
R
R/W R/W R/W
Bits 15 to 3—Reserved: These bits are always read as 0.
Bit 2—RAM Select (RAMS): Specifies selection or non-selection of flash memory emulation in
RAM. When RAMS = 1, all flash memory block are program/erase-protected.
Bit 2:
RAMS
0
1
Description
Emulation not selected
Program/erase-protection of all flash memory blocks is disabled
Emulation selected
Program/erase-protection of all flash memory blocks is enabled
(Initial value)
Rev. 5.00 Jan 06, 2006 page 603 of 818
REJ09B0273-0500