SH7050 Datasheet, PDF (555/841 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH RISC engine Family/

Section 18 ROM (128 kB Version)
Section 18 ROM (128 kB Version)
18.1 Features
The SH7050 has 128 kbytes of on-chip flash memory. The features of the flash memory are
summarized below.
• Four flash memory operating modes
 Program mode
 Erase mode
 Program-verify mode
 Erase-verify mode
• Programming/erase methods
The flash memory is programmed 32 bytes at a time. Block erase (in single-block units) can be
performed. Erasing the entire memory requires erasure of each block in turn. Block erasing can
be performed as required on 1 kB, 28 kB, and 32 kB blocks.
• Programming/erase times
The flash memory programming time is 10 ms (typ.) for simultaneous 32-byte programming,
equivalent to 300 µs (typ.) per byte, and the erase time is 100 ms (typ.).
• Reprogramming capability
The flash memory can be reprogrammed up to 100 times.
• On-board programming modes
There are two modes in which flash memory can be programmed/erased/verified on-board:
 Boot mode
 User program mode
• Automatic bit rate adjustment
With data transfer in boot mode, the SH7050’s bit rate can be automatically adjusted to match
the transfer bit rate of the host.
• Flash memory emulation in RAM
flash memory programming can be emulated in real time by overlapping a part of RAM onto
flash memory.
• Protect modes
There are two protect modes, hardware and software, which allow protected status to be
designated for flash memory program/erase/verify operations
Rev. 5.00 Jan 06, 2006 page 535 of 818
REJ09B0273-0500