SH7050 Datasheet, PDF (199/841 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperH RISC engine Family/

Section 9 Direct Memory Access Controller (DMAC)
Burst Mode, Single Address, and Level Detection: DREQ sampling timing in burst mode with
single address and level detection is shown in figures 9.21 and 9.22.
In burst mode with single address and level detection, a dummy cycle is inserted as one bus cycle,
at the earliest, three cycles after timing of the first sampling. Data during this period is undefined,
and the DACK signal is not output. Nor is the number of DMAC transfers counted. The actual
DMAC transfer begins after one dummy bus cycle output.
The dummy cycle is not counted either at the start of the second sampling (transfer one bus cycle
before the start of the first DMAC transfer). Therefore, the second sampling is not conducted from
the bus cycle starting the dummy cycle, but from the start of the CPU(3) bus cycle.
Thereafter, as long the DREQ is continuously sampled, no dummy cycle is inserted. DREQ
sampling timing during this period begins from the start of the transfer one bus cycle before the
start of DMAC transfer, in the same way as with cycle steal mode.
As with the four samplings in figure 9.21, once DMAC transfer is interrupted, a dummy cycle is
again inserted at the start as soon as DMAC transfer is resumed.
The DACK output period in burst mode is the same as in cycle steal mode.
Rev. 5.00 Jan 06, 2006 page 179 of 818
REJ09B0273-0500