SH7211 Datasheet, PDF (991/1228 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family

Section 21 Flash Memory
(7) Programming/Erasure State
In this state, the boot program must select the form of programming corresponding to the
programming-selection command and then write data in response to 256-byte programming
commands, or perform erasure in block units in response to the erasure-selection and block-
erasure commands.
The programming and erasure commands are listed in table 21.13.
Table 21.13 Programming and Erasure Commands
Command
H'42
H'43
H'50
H'48
H'58
H'52
H'4A
H'4B
H'4C
H'4D
H'4F
Command Name
Function
Selection of user boot Selects transfer of the program for user boot MAT
MAT programming
programming.
Selection of user MAT Selects transfer of the program for user MAT programming.
programming
256-byte programming Executes 256-byte programming.
Erasure selection
Selects transfer of the erasure program.
Block erasure
Executes erasure of the specified block.
Memory read
Reads from memory.
Sum checking of user Executes sum checking of the user boot MAT.
boot MAT
Sum checking of user Executes sum checking of the user MAT.
MAT
Blank checking of user Executes blank checking of the user boot MAT.
boot MAT
Blank checking of user Executes blank checking of the user MAT.
MAT
Inquiry on boot
program state
Requests information on the state of boot processing.
Rev. 2.00 May. 08, 2008 Page 967 of 1200
REJ09B0344-0200