SH7211 Datasheet, PDF (923/1228 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family

Section 21 Flash Memory
Initial
Bit
Bit Name Value R/W Description
4
FLER
0
R
Flash Memory Error
Indicates an error occurs during programming and erasing
flash memory.
When FLER is set to 1, flash memory enters the error
protection state.
When FLER is set to 1, high voltage is applied to the
internal flash memory. To reduce the damage to flash
memory, the reset signal must be released after the reset
period of 100 μs which is longer than normal.
0: Flash memory operates normally
Programming/erasing protection for flash memory (error
protection) is invalid.
[Clearing condition]
At a power-on reset
1: Indicates an error occurs during programming/erasing
flash memory.
Programming/erasing protection for flash memory (error
protection) is valid.
[Setting condition]
See section 21.6.3, Error Protection.
3 to 1 ⎯
All 0 R
Reserved
These bits are always read as 0. The write value should
always be 0.
Rev. 2.00 May. 08, 2008 Page 899 of 1200
REJ09B0344-0200