LAN9353 Datasheet, PDF (464/523 Pages) Microchip Technology – Interfaces at up to 200Mbps via Turbo MII

LAN9353
Bits
Description
4
TX IP Address Enable (TX_IP_ADDR_EN)
This bit enables the checking of the IP destination address in PTP messages
for both IPv4 and IPv6 formats.
Note:
The host S/W must not change this bit while the 1588 Enable
(1588_ENABLE) bit in 1588 Command and Control Register
(1588_CMD_CTL) is set.
3
TX MAC Address Enable (TX_MAC_ADDR_EN)
This bit enables the checking of the MAC destination address in PTP mes-
sages.
Note:
The host S/W must not change this bit while the 1588 Enable
(1588_ENABLE) bit in 1588 Command and Control Register
(1588_CMD_CTL) is set.
2
TX Layer 2 Enable (TX_LAYER2_EN)
This bit enables the detection of the layer 2 formatted PTP messages.
Note:
The host S/W must not change this bit while the 1588 Enable
(1588_ENABLE) bit in 1588 Command and Control Register
(1588_CMD_CTL) is set.
1
TX IPv6 Enable (TX_IPV6_EN)
This bit enables the detection of the UDP/IPv6 formatted PTP messages.
Note:
The host S/W must not change this bit while the 1588 Enable
(1588_ENABLE) bit in 1588 Command and Control Register
(1588_CMD_CTL) is set.
0
TX IPv4 Enable (TX_IPV4_EN)
This bit enables the detection of the UDP/IPv4 formatted PTP messages.
Note:
The host S/W must not change this bit while the 1588 Enable
(1588_ENABLE) bit in 1588 Command and Control Register
(1588_CMD_CTL) is set.
Type
R/W
R/W
R/W
R/W
R/W
Default
1b
1b
1b
1b
1b
DS00001925A-page 464
 2015 Microchip Technology Inc.