LAN9353 Datasheet, PDF (312/523 Pages) Microchip Technology – Interfaces at up to 200Mbps via Turbo MII

LAN9353
10.7.3.25 Switch Engine Admit Non Member Register (SWE_ADMT_N_MEMBER)
Register #:
1849h
Size:
32 bits
This register is used to allow access to a VLAN even if the ingress port is not a member.
Bits
Description
31:3 RESERVED
2:0 Admit Non Member
When set, a received packet is accepted even if the ingress port is not a
member of the destination VLAN. The VLAN still must be active in the switch.
There is one bit per ingress port. Bits 2,1,0 correspond to switch ports 2,1,0
respectively.
Type
RO
R/W
Default
-
000b
10.7.3.26 Switch Engine Ingress Rate Configuration Register (SWE_INGRSS_RATE_CFG)
Register #:
184Ah
Size:
32 bits
This register, along with the settings accessible via the Switch Engine Ingress Rate Command Register (SWE_IN-
GRSS_RATE_CMD), is used to configure the ingress rate metering/coloring.
Bits
Description
31:3 RESERVED
2:1 Rate Mode
These bits configure the rate metering/coloring mode.
00 = Source Port & Priority
01 = Source Port Only
10 = Priority Only
11 = RESERVED
0
Ingress Rate Enable
When set, ingress rates are metered and packets are colored and dropped if
necessary.
Type
RO
R/W
R/W
Default
-
00b
0b
DS00001925A-page 312
 2015 Microchip Technology Inc.