HD64F2145 Datasheet, PDF (149/829 Pages) Renesas Technology Corp – Hitachi 16-Bit Single-Chip Microcomputer

5.7.4 Usage Notes
1. In an address break, the break address should be an address where the first byte of the
instruction exists. Otherwise, a break condition will not be satisfied.
2. In normal mode, addresses A23 to A16 are not compared.
3. When the branch instructions (Bcc, BSR), jump instructions (JMP, JSR), RST instruction, and
RTE instruction are placed immediately prior to the address specified by BAR, a prefetch
signal to the address may be output to request an address break by executing these instruction.
It is necessary to take countermeasures: do not set a break address to an address immediately
after these instructions, or determine whether interrupt handling is performed by satisfaction of
a normal condition.
4. An address break interrupt is generated by combining the internal prefetch signal and an
address. Therefore, the timing to enter the interrupt exception handling differs according to the
instructions at the specified and at prior addresses and execution cycles.
Figure 5.10 shows an example of address timing.
Rev. 2.0, 08/02, page 109 of 788