SH7144_08 Datasheet, PDF (126/930 Pages) Renesas Technology Corp – 32-Bit RISC Microcomputer SuperHTM RISC engine Family/SH7144 Series

6. Interrupt Controller (INTC)
6.3.2 Interrupt Control Register 2 (ICR2)
ICR2 is a 16-bit register that sets the edge detection mode of the external interrupt input pins IRQ0
to IRQ7. ICR2 is, however, valid only when IRQ interrupt request detection mode is set to the
edge detection mode by the sense select bits of IRQ0 to IRQ 7 in Interrupt control register 1
(ICR1). If the IRQ interrupt request detection mode has been set to low level detection mode, the
setting of ICR2 is ignored.
Bit Bit Name Initial Value R/W Description
15 IRQ0ES1 0
14 IRQ0ES0 0
R/W This bit sets the IRQ0 interrupt request edge
R/W ^{detection mode.}
00: Interrupt request is detected on falling edge of
IRQ0 input
01: Interrupt request is detected on rising edge of
IRQ0 input
10: Interrupt request is detected on both of falling
and rising edge of IRQ0 input
11: Cannot be set
13 IRQ1ES1 0
12 IRQ1ES0 0
R/W This bit sets the IRQ1 interrupt request edge
R/W ^{detection mode.}
00: Interrupt request is detected on falling edge of
IRQ1 input
01: Interrupt request is detected on rising edge of
IRQ1 input
10: Interrupt request is detected on both of falling
and rising edge of IRQ1 input
11: Cannot be set
11 IRQ2ES1 0
10 IRQ2ES0 0
R/W This bit sets the IRQ2 interrupt request edge
R/W ^{detection mode.}
00: Interrupt request is detected on falling edge of
IRQ2 input
01: Interrupt request is detected on rising edge of
IRQ2 input
10: Interrupt request is detected on both of falling
and rising edge of IRQ2 input
11: Cannot be set
Rev.4.00 Mar. 27, 2008 Page 82 of 882
REJ09B0108-0400