HD64F2168 Datasheet, PDF (728/874 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer

• Command, H'50, (1 byte): 128-byte programming
• Programming Address (4 bytes): Start address for programming
Multiple of the size specified in response to the programming unit inquiry
(i.e. H'00, H'01, H'00, H'00 : H'010000)
• Programming Data (128 bytes): Data to be programmed
The size is specified in the response to the programming unit inquiry.
• SUM (1 byte): Checksum
Response H'06
• Response, H'06, (1 byte): Response to 128-byte programming
On completion of programming, the boot program will return ACK.
Error Response H'D0 ERROR
• Error response, H'D0, (1 byte): Error response for 128-byte programming
• ERROR: (1 byte): Error code
H'11: Checksum Error
H'2A: Address Error
H'53: Programming error
A programming error has occurred and programming cannot be continued.
The specified address should match the unit for programming of data. For example, when the
programming is in 128-byte units, the lower 8 bits of the address should be H'00 or H'80.
When there are less than 128 bytes of data to be programmed, the host should fill the rest with
H'FF.
Sending the 128-byte programming command with the address of H'FFFFFFFF will stop the
programming operation. The boot program will interpret this as the end of the programming and
wait for selection of programming or erasing.
Command H'50 Address SUM
• Command, H'50, (1 byte): 128-byte programming
• Programming Address (4 bytes): End code is H'FF, H'FF, H'FF, H'FF.
• SUM (1 byte): Checksum
Response H'06
• Response, H'06, (1 byte): Response to 128-byte programming
On completion of programming, the boot program will return ACK.
Error Response H'D0 ERROR
• Error Response, H'D0, (1 byte): Error response for 128-byte programming
Rev. 3.00, 03/04, page 688 of 830