HD64F2168 Datasheet, PDF (447/874 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer

14.7 Smart Card Interface Description
The SCI supports the IC card (smart card) interface based on the ISO/IEC 7816-3 (Identification
Card) standard as an enhanced serial communication interface function. Smart card interface mode
can be selected using the appropriate register.
14.7.1 Sample Connection
Figure 14.24 shows a sample connection between the smart card and this LSI. As in the figure,
since this LSI communicates with the IC card using a single transmission line, interconnect the
TxD and RxD pins and pull up the data transmission line to VCC using a resistor. Setting the RE
and TE bits in SCR to 1 with the IC card not connected enables closed transmission/reception
allowing self diagnosis. To supply the IC card with the clock pulses generated by the SCI, input
the SCK pin output to the CLK pin of the IC card. A reset signal can be supplied via the output
port of this LSI.
VCC
TxD
RxD
SCK
Rx (port)
This LSI
Main unit of the device
to be connected
Data line
Clock line
Reset line
I/O
CLK
RST
IC card
Figure 14.24 Pin Connection for Smart Card Interface
14.7.2 Data Format (Except in Block Transfer Mode)
Figure 14.25 shows the data transfer formats in smart card interface mode.
• One frame contains 8-bit data and a parity bit in asynchronous mode.
• During transmission, at least 2 etu (elementary time unit: time required for transferring one bit)
is secured as a guard time after the end of the parity bit before the start of the next frame.
• If a parity error is detected during reception, a low error signal is output for 1 etu after 10.5 etu
has passed from the start bit.
• If an error signal is sampled during transmission, the same data is automatically re-transmitted
after two or more etu.
Rev. 3.00, 03/04, page 407 of 830