HD64F2168 Datasheet, PDF (690/874 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer

1. Select the on-chip program to be downloaded
Set the EPVB bit in FECS to 1.
Several programming/erasing programs cannot be selected at one time. If several programs are
set, download is not performed and a download error is reported to the SS bit in the DPFR
parameter.
Specify the start address of a download destination by FTDAR.
The procedures to be carried out after setting FKEY, e.g. download and initialization, are the
same as those in the programming procedure. For details, refer to Programming Procedure in
User Program Mode in section 20.4.2, sub-section (2).
The procedures after setting parameters for erasing programs are as follows:
2. Set the FEBS parameter necessary for erasure
Set the erase block number of the user MAT in the flash erase block select parameter FEBS
(general register ER0). If a value other than an erase block number of the user MAT is set, no
block is erased even though the erasing program is executed, and an error is returned to the
return value parameter FPFR.
3. Erasure
Similar to as in programming, there is an entry point of the erasing program in the area from
the start address of a download destination specified by FTDAR + 16 bytes of on-chip RAM.
The subroutine is called and erasing is executed by using the following steps.
MOV.L
JSR
NOP
#DLTOP+16,ER2
@ER2
; Set entry address to ER2
; Call erasing routine
• The general registers other than R0L are held in the erasing program.
• R0L is a return value of the FPFR parameter.
• Since the stack area is used in the erasing program, a stack area of 128 bytes at the
maximum must be allocated in RAM.
4. The return value in the erasing program, FPFR (general register R0L) is determined.
5. Determine whether erasure of the necessary blocks has completed.
If more than one block is to be erased, update the FEBS parameter and repeat steps 2 to 5.
Blocks that have already been erased can be erased again.
6. After erasure completes, clear FKEY and specify software protection.
If this LSI is restarted by a reset immediately after user MAT erasure has completed, secure
the reset period (period of RES = 0) of 100 µs which is longer than normal.
Rev. 3.00, 03/04, page 650 of 830