HD64F2168 Datasheet, PDF (658/874 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer

20.1.5 Programming/Erasing Interface
Programming/erasing is executed by downloading the on-chip program to the on-chip RAM and
specifying the program address/data and erase block by using the interface register/parameter.
The procedure program is made by the user in user program mode and user boot mode. An
overview of the procedure is given as follows. For details, see section 20.4.2, User Program Mode.
Start user procedure
program for programming/erasing.
Select on-chip program to be
downloaded and
specify the destination.
Download on-chip program
by setting FKEY and SCO bits.
Initialization execution
(downloaded program execution)
Programming (in 128-byte units)
or erasing (in one-block units)
(downloaded program execution)
Programming/erasing
No
completed?
Yes
End user procedure
program
Figure 20.5 Overview of User Procedure Program
1. Selection of on-chip program to be downloaded
For programming/erasing execution, the FLSHE bit in STCR must be set to 1 to transition to
user program mode.
This LSI has programming/erasing programs which can be downloaded to the on-chip RAM.
The on-chip program to be downloaded is selected by setting the corresponding bits in the
programming/erasing interface register. The address of the programming destination is
specified by the flash transfer destination address register (FTDAR).
Rev. 3.00, 03/04, page 618 of 830